What are the thickness adjustment methods of broadband sander?

Broadband sander with the development of science, its adjustment methods are becoming more and more intelligent, so what are the thickness adjustment methods of broadband sander? The following small talk with you.

Broadband sander thickness adjustment methods are as follows.

1. Broadband sander grinding volume distribution The backward method is generally used. First determine the last grinding volume, then determine the last second grinding volume, and finally determine the first grinding volume.

Example: Company A adopts the “4×4″ grinding combination, and according to the market requirements on the quality of the plate, the final requirement is 15 kiln belts with a total grinding capacity of 2.2~2.8 mm. according to the above conditions, the grinding belts are firstly selected as 4 mm, 8 mm, 12 mm and 150 mm, and then the fifth grinding volume is 0.15 mm (double-sided Combined sanding frame grinding pad), the third grinding volume is 0.5 mm. the remaining 1~1.6 mm is the first grinding volume.

2. The operation of broadband sander grinding volume allocation is performed in a pass-by-pass operation. First, the size of the plate thickness after each grinding completion is determined according to the allocated grinding volume. According to the determined plate thickness size, first take sand and then take several sanding belts. After the first sanding plate thickness size meets the requirement, put on the first sanding belt for sanding and determine the second sanding plate thickness size. And so on, until the last size meets the requirements. Usually, in determining each size, at least two sanding plates meet the size requirements to ensure that the sanding has been properly adjusted.

The above content is the thickness adjustment method of the broadband sander. After the adjustment is completed according to the above method, there is generally no need to make major adjustments in the future, even when changing the specifications of the plate, but for this purpose the position of the eccentric wheel and the grinding pad should be recorded to avoid the need for readjustment caused by misuse. After the adjustment is completed, there is generally no need to make major adjustments even when the specifications of the plates are changed, but for this purpose the position of the eccentric wheel and the grinding pad should be recorded to avoid the need for readjustment caused by misuse.